HYDRIM C51w & C51wd Hydrim Instrument Washers & Washer-Disinfectors. Perfectly prepares instruments for sterilization in as little as 19 minutes. Downloads Brochure English Brochure Français Brochure Deutsch Brochure Español Safer for your staff, Kinder to your instruments A Higher Standard Authorities now recommend that dental instruments must first be processed in a mechanical washer or washer-disinfector prior to sterilisation. Across Europe, standards and guidelines (EN15883 / RKI / BDA Advice Sheet A12) reflect this advice. Effective sterilisation begins with the Hydrim® C51wd washer disinfector or C51w washer which automatically washes, rinses, disinfects and dries dental instruments, simply by pressing the icons on the touch screen. The Hydrim process begins with a powerful pre-wash cycle. Then two independent, high-pressure sprays clean the instrument load from above and below removing virtually all organic debris. Cleaning solution is dispensed automatically and clean water is used with every new cycle. Independent tests show the Hydrim to have a protein removal efficacy of 99.9 - 100%. Hydrim eliminates the soaking, scrubbing and rinsing associated with traditional pre-sterilisation processes. In the C51wd disinfection at 80°C for ten minutes following the washing phase renders the instruments safe to handle. The chemicals in ultrasonic baths are typically changed once per day. Microbial load builds throughout the day and instruments are often cleaned for variable periods of time. In contrast, mechanical washing in the Hydrim is more efficient than an ultrasonic bath because Hydrim is consistent, more powerful and uses only single-use water and detergent chemicals. If it isn’t clean? It can’t be sterilised! Hydrim Cleaning Solution with instrument protection (HIP) has been formulated to achieve excellent cleaning results while assuring exceptional compatibility with a wide range of metals and coatings used in dental instruments. Your valuable instruments will be protected better and for longer by the HIP formulation. SciCan’s patented HIP cleaning solution, combined with Hydrim’s specially designed wash programme, provides a superior washing system which perfectly prepares your instruments for sterilisation with a Statim, Quantim B2® or other sterilising process. Active Drying System Drying of instruments after cleaning, and before wrapping, is recommended by major instrument manufacturers to prevent corrosion . The Hydrim C51w / wd has an active drying system that circulates warm air throughout the chamber following the cycle. In the C51wd, a built-in dryer with Hepa filter (user changeable) ensures that instruments are dried with air free of contaminants. Since instruments are already warm due to the elevated temperature during disinfection, they dry in less than 10 minutes. The drying time can be extended or reduced if desired. The drying cycle of the Hydrim eliminates the need for practice staff to pat instruments dry, as they would usually do following manual scrubbing or processing in an ultrasonic cleaner. This further reduces the risk of staff injury, and saves valuable time. HYDRIM C51wd Cycles Cycle P1 Regular Cycle P2 Heavy Duty Cycle P3 Heavy Duty Cycle with Disinfection Description Use for moderately soiled instruments. Use for heavily soiled instruments. Use for heavily soiled instruments and cassettes. Cold pre-wash <45°C <45°C <45°C Wash 50°C 5 minutes 50°C 9 minutes 50°C 9 minutes Rinse/disinfection 60°C 60°C 80°C 10 minutes Dry 0-15 min. 0-15 min. 0-15 min. Total time* without drying 19 minutes 23 minutes 45 minutes Water consumption 13L 13L 13L HYDRIM C51w Cycles Cycle Rinse & Hold Regular Wash & Dry Heavy Duty Wash & Dry Description Use to prevent soil from drying on instruments and if wash cycle is not immediately desired. Use for moderately soiled loose instruments Use for heavily soiled instruments or cassettes or if using the cannula post. Cold pre-wash <45°C <45°C <45°C Wash N/A 5 minutes 9 minutes Rinse/disinfection 60°C 60°C 60°C Dry N/A 10 minutes (factory pre-set time). Can be extended. 10 minutes (factory pre-set time). Can be extended. Total time* without drying 8 minutes 9 minutes 23 minutes Water consumption 6L 14L 14L * Cycle times depend on the temperature and pressure of incoming water Hydrim C51 Cycles. Record Keeping A datalogger is available as an optional accessory. It connects into an RS232 9 pin port and automatically captures the parameters of the cleaning and disinfection cycle(s) within a text file on a USB stick. Afterwards these files can be saved from the USB stick onto the mainframe computer in the practice. Datalogger The RS232 9 pin port offers the user the option to connect to a selection of standard printers. Accessories Hinged instrument rack 15793.00 192 x 100 x 109 mm Large basket 01-108232 442 x 150 x 42 mm Basket with hinged lid 01-108294 216 x 140 x 54 mm Hygiene basket 01-108298 203 x 114 x 32 mm Statim 2000 basket 01-107240 275 x 178 x 42 mm Statim 5000 basket 01-107241 373 x 178 x 42mm Support rack 01-108214 350 x 350 x 48 mm HIP cleaning solution CS-HIPC 4 x 1.9L 4-cassette rack 01-109153 380 x 385 x 160mm 1-cassette rack 01-107242 388 x 156 x 160 mm Rack for Vertical Instruments 15555.01 Rack for two cassettes and two baskets 01-109768S SYS-TM Instrument Cassettes SYS-TM1 – 178 x 64 x 13 mm SYS-TM2 – 178 x 64 x 25 mm SYS-TM3 – 178 x 114 x 13 mm SYS-TM4B – 267 x 165 x 25 mm Specifications Unit Size: D 460 mm x W 600 mm x H 475 mm Depth with Door Open: 78 cm Weight: 35 kg Running Noise: 60 dBA Water Softener Standard Drying system Heater 1kW with Blower Hot and cold water connections G ¾"/19mm Drain ¾"/19mm Inlet water pressure 1-10bar Electrical Connection: 220-240V, 50Hz, 10 amp Independent second temperature sensor Standard Independent monitoring of chemical dosing Standard Independent monitoring of circulation pumps Standard RS 232 data port Standard Test port (C51wd only) Standard